Pontiac Roof Rack Installation And Review Videos

Thule AeroBlade Crossroad Roof Rack Installation - 2008 Pontiac Vibe- Video

Alright on this 2008 Pontiac Vibe, we're going to do a test fit of Thule Roof Rack System. We will be using a Thule Rapid Aero Foot Pack and a Thule AeroBlade Load Bars 47 inches wide. Okay, we're going to start off with our test fit with our roof rack already assembled according to the instructions. So what I'm going to do is put it on the factory roof rack. We'll start of by placing the load bar in the center of the factory roof rack where there is most room and then we'll go ahead and slide it up towards the front. To make sure that our load bars are square, we'll measure from the edge of the factory roof rack to the center of the foot pack on both sides. more

2/28/2012 2:59:58 PM

Thule Crossroad Roof Rack Installation - 2008 Pontiac Vibe- Video

Alright, today on this 2008 Pontiac Vibe were going to do a test fit of the Thule Crossroad roof rack using part #: thlb50 and #: th450. Were going to start off with our load bars already assembled according to the instructions, so all we have to do is place them on the factory roof rack. Well start by placing our first load bar in the middle of the roof rack, then scoot it towards the front. Now to square up our bars were going to measure off an edge off the factory roof rack to the center or the Crossroads foot pack. In this case well be using a measurement of 3 inches, but this measurement will vary depending on the type of accessories that you will use. With the load bar in the correct spot well make sure that the bar is even on both sides. more

2/27/2012 1:31:25 PM

Thule Crossroad Roof Rack Installation - 2007 Pontiac Torrent- Video

Today on our 2007 Pontiac Torrent well be test fitting the Thule crossroads roof rack system using part #: th450 and #: thlb50. With our crossbars already preassembled were ready to go ahead and fit it to the vehicle. Well begin by simply setting the front crossbar in a place over the side rails, well line up the small black triangle on each of the feet directly over the side rails. Well then use the rubber coated steel straps to bring it around and hook it to the foot pad. We can then use the included tool within each foot to tighten down and secure the crossbar. With our front crossbar secured to the vehicle were now ready to move on to the rear crossbar. more

2/27/2012 1:29:47 PM